Locate the "Learn" or "Program" button on your garage door opener motor unit. The keypad should be programmed.Once you've selected a compatible keypad, follow these steps to program it: Slide the switch back to operate and plug the garage door opener back in. Next, enter your desired four digit PIN number into the keypad. Flip the operate/program switch to program. To program the keypad, first unplug the garage door opener from the electrical outlet. Would I have to switch this to the PROGRAM mode to change the code?" I took a small plate off the front and it has a 9 volt battery and a switch that says PROGRAM and OPERATE. "Yes, it has wires that go through the wall and plug into a wall mounted push button door opener. I have the code from the previous owners but would like to change it to my own code. The keypad only has numbers 0-9 and no ENTER button, so I can't push the button on the opener and walk to the keypad, enter the new 4 digit code and push enter, because there is no ENTER button. I am trying to change the code but am unable to. "I have a Craftsman 1/2 horse GDO model 41A4315-7D and a Keyless entry keypad model 31D302A. I would use a fresh battery before starting this. Okay, I found these instructions at this link: Thank you all very much for your help with this rather frustrating affair, and a special thanks to vln12 for providing the final solution. I then flipped the switch inside, typed in my new code, and flipped the switch back, and my new code was programmed. SOLUTION: I had to open the front plate of the button that the keypad is wired to.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |